Dometic refrigerator owner manual

NOTE: Black water check valve must be reinstalled to ensure proper refrigerator operation. In vehicles where routing the drain hose through the floor is not possible, a metal clip is available.

The clip is used to drain water out through the side vent. Part No. When installing the refrigerator in the enclosure, all areas within the recess in which the refrigerator is installed must be sealed. Make sure that there is a complete seal between the front frame of the refrigerator and the top, sides and bottom of the enclosure. A length of sealing strip is applied to the rear surface of the front frame for this purpose. Also apply a sealing strip to the foremost floor of the enclosure and apply a second sealing strip to the bottom of the trim strip on the front base as shown in FIG.

The sealing should provide complete isolation of the appliance's combustion system from the vehicle interior. A wood strip must be in place across the upper opening of the enclosure.

The top frame of the refrigerator will be anchored to the wood strip with screws. See FIG. The dimensions shown in FIG. NOTE : If the door is hinged and it needs be changed to the opposite side, it must be done before the refrigerator is installed in the enclosure.

See Step. NOTE : Be careful not to damage the sealing strip applied to the floor of the enclosure when the refrigerator is put in place. The refrigerator is secured in the enclosure with six screws. They must be installed in the following order:. First: Two screws are installed in front decoration strip and through the front base. The strip is shipped as a loose part. The hinge plate can be on the right or left side depending on the door swing.

The second screw is installed with a washer on the opposite side. Open refrigerator door and gently push the tabs out of the hole in the hinge with flat blade screwdriver. Be careful not to pinch the wires. Make sure the tabs snap back into the holes in the hinge plate. Third: Two screws installed as shown in rear base. Failure to follow the sequence in securing the refrigerator in the enclosure can cause leakage between the frame and cabinet.

One problem with the Dometic brand is that companies install custom buttons in different places in different styles. The button can be at any place as it depends on your refrigerator type. Some models have a reset button; some do not.

Some models have the button in the freezer, and you have to adjust the two or three modes by turning it on and off again. If you do not find it by yourself, then your source is the user guide. A picture of all parts of your fridge should be available so you can find it quickly if you have one. Sometimes manually going with the reset process is confusing because it takes a few wires to get the job done without the reset button to click.

You need to correct the working mechanism of your RV fridge. This can make things simpler for you whenever anything goes wrong. Then Grab this easy-to-read illustrated eBook. Also, this eBook will help you understand RV Life and help you with the journey all the way. There is a thermostat in the refrigerator compartment and another in the freezer compartment. They are in a metal box on the right side of your fridge.

Service Instruction. EC EGP. Elite RM Operating Insructions. Frigo DC HC Series. HiPro HiPro Vision. HiPro Series. HiPro Vision KS Instruction Book. Mini Cool series. NDR Installation And Operating Instructions Manual. New Dimensions. New Generations. PowerFridge RC R A. R 90 AC. RA RA and. RC RC EGP. RC GC. RC Series. RGE RGE Series.

RH LDA. RH D. RH RH LD. RH L.